Small Pubs - melded vs panel mount piezo
Posted: Tue Mar 23, 2021 3:34 pm
hi,
Finally started the build of 2 x WH6, wont post pictures until all gaps have been well and truly filled and Duratexed over , oops. !
Weighing up the pros and cons of the melded vs panel mount piezos.
-Need two monitors at front as sax player wants to be LOUD and singer is getting overpowered currently with the single shared monitor.
As we play some very small "stages" (floor space in pubs bascially ) , often close to a side wall (or two!) would you say its better to go for narrower melded array - Widths of the stage spaces in these small UK pubs are from 10-20ft normally - just a bit concerned that the wider HF dispersion might cause issues bouncing off walls as monitors might be within 4 or 5 foot of a sidewall sometimes?
Any ideas gents (and ladies!) from those whose used any WH in smaller venues before I start cutting the next parts...
(Did even consider building both in one cab with a switch to swap over , but that may be poor idea given Monacor prices in UK post Brexit (ouch!!) and lack of Goldwoods that can be sourced.
Many Thanks and look forward to using them -we have a post lockdown ending gig in July !!- review will follow!
Al
Finally started the build of 2 x WH6, wont post pictures until all gaps have been well and truly filled and Duratexed over , oops. !
Weighing up the pros and cons of the melded vs panel mount piezos.
-Need two monitors at front as sax player wants to be LOUD and singer is getting overpowered currently with the single shared monitor.
As we play some very small "stages" (floor space in pubs bascially ) , often close to a side wall (or two!) would you say its better to go for narrower melded array - Widths of the stage spaces in these small UK pubs are from 10-20ft normally - just a bit concerned that the wider HF dispersion might cause issues bouncing off walls as monitors might be within 4 or 5 foot of a sidewall sometimes?
Any ideas gents (and ladies!) from those whose used any WH in smaller venues before I start cutting the next parts...
(Did even consider building both in one cab with a switch to swap over , but that may be poor idea given Monacor prices in UK post Brexit (ouch!!) and lack of Goldwoods that can be sourced.
Many Thanks and look forward to using them -we have a post lockdown ending gig in July !!- review will follow!
Al