What size roundover bit is appropriate to use with 1/4" BB ply? Want the edges to be as "soft" as possible. Is a 1/4" radius bit too much?
Just the outside edges and port/hand hole. Don't want to bullnose the mouth.
Thanks guys
WH6, what radius roundover bit for 1/4" ply
WH6, what radius roundover bit for 1/4" ply
Build in process - 2 WH6, one Alpha 6a loaded, one PRV Audio 6MB250-NDY loaded
Two 2x6 shorty SLA Pro's
One T39, 16", 3012LF loaded
Tall AutoTuba, 20" wide, 2x 8" MCM 55-2421
TruckTuba, 8½" wide, 2x 8" MCM 55-2421
Two 2x6 shorty SLA Pro's
One T39, 16", 3012LF loaded
Tall AutoTuba, 20" wide, 2x 8" MCM 55-2421
TruckTuba, 8½" wide, 2x 8" MCM 55-2421
-
- Posts: 6915
- Joined: Mon Nov 28, 2011 11:12 am
- Location: Ilfracombe Queensland Australia
- Contact:
Re: WH6, what radius roundover bit for 1/4" ply
Hey Seth,
Rather than a round over, I'd be inclined to Aris the wood (ie knock the edge off with a plane) then sand to suit.
Far to easy with 1/4" ply to take to much with a round over, and it's hard to put back again...
Rather than a round over, I'd be inclined to Aris the wood (ie knock the edge off with a plane) then sand to suit.
Far to easy with 1/4" ply to take to much with a round over, and it's hard to put back again...
Built:
DR 250: x 2 melded array, 2x CD horn, March 2012 plans.
T39's: 4 x 20" KL3010LF , 2 x 28" 3012LF.
WH8: x 6 with melded array wired series/parallel.
Bunter's Audio and Lighting "like"s would be most appreciated...
DR 250: x 2 melded array, 2x CD horn, March 2012 plans.
T39's: 4 x 20" KL3010LF , 2 x 28" 3012LF.
WH8: x 6 with melded array wired series/parallel.
Bunter's Audio and Lighting "like"s would be most appreciated...
- Bill Fitzmaurice
- Site Admin
- Posts: 28645
- Joined: Tue May 02, 2006 5:59 pm
Re: WH6, what radius roundover bit for 1/4" ply
Even using a 3/8" radius only reduces the minimum cross section at the joint by 1/16". A 1/4" radius doesn't reduce it at all.
Re: WH6, what radius roundover bit for 1/4" ply
Thanks guys. Much appreciated
Build in process - 2 WH6, one Alpha 6a loaded, one PRV Audio 6MB250-NDY loaded
Two 2x6 shorty SLA Pro's
One T39, 16", 3012LF loaded
Tall AutoTuba, 20" wide, 2x 8" MCM 55-2421
TruckTuba, 8½" wide, 2x 8" MCM 55-2421
Two 2x6 shorty SLA Pro's
One T39, 16", 3012LF loaded
Tall AutoTuba, 20" wide, 2x 8" MCM 55-2421
TruckTuba, 8½" wide, 2x 8" MCM 55-2421