Plan Errors

Anything not covered elsewhere.
Post Reply
Message
Author
mj90210
Posts: 79
Joined: Fri Feb 03, 2017 2:12 pm
Location: Montana-USA

Plan Errors

#1 Post by mj90210 »

Preface: I am not trying to be Poindexter type and I didn't want to contact Mr. Fitzmaurice via email.

Where should I comment or post about errors in plans that I have found?

Thanks
Thank You All for Your Time!!...Really!

Built:
2xDR300's
4xDual-30” Tuba 60’s
Simplex 21" Eminence NSW6021
1x20” THT
TLAH‘S
SLA Center-9 driver and Surrounds
SLA pros
TrT 10" Driver-10" Wide
Auto Tuba 10" Driver

User avatar
Bill Fitzmaurice
Site Admin
Posts: 28620
Joined: Tue May 02, 2006 5:59 pm

Re: Plan Errors

#2 Post by Bill Fitzmaurice »

Post it in the forum for the speaker, then we'll tell you why it's not an error. :)

It does happen, but usually is found and fixed within a fairly short period after the plans are released.
If you did email me I probably wouldn't see it anyway. Only personal emails get past the screening process. Besides, if there is an error that's something that should be known by everyone of interest.

mj90210
Posts: 79
Joined: Fri Feb 03, 2017 2:12 pm
Location: Montana-USA

Re: Plan Errors

#3 Post by mj90210 »

10-4!
Thank You All for Your Time!!...Really!

Built:
2xDR300's
4xDual-30” Tuba 60’s
Simplex 21" Eminence NSW6021
1x20” THT
TLAH‘S
SLA Center-9 driver and Surrounds
SLA pros
TrT 10" Driver-10" Wide
Auto Tuba 10" Driver

himhimself
Posts: 599
Joined: Fri Nov 13, 2015 9:34 pm
Location: Vancouver BC & Bloomington IN

Re: Plan Errors

#4 Post by himhimself »

gotta say, plans are pretty darn accurate across the board. However, panel jig word doc, page 5. Illustration is correct, but plans say 2 x 19 inch end cap. Should be 2 x 10. Just in the spirit of continuous improvement :D
2xT30 (20", 3012LF)
2xT30 (21", 3012LF)
4xOtop J-array (Beta12, melded/straight piezos)
Truck Tuba (MCM)
Next up: 2xJack12 or family of table tubas

Post Reply