Preface: I am not trying to be Poindexter type and I didn't want to contact Mr. Fitzmaurice via email.
Where should I comment or post about errors in plans that I have found?
Thanks
Plan Errors
Plan Errors
Thank You All for Your Time!!...Really!
Built:
2xDR300's
4xDual-30” Tuba 60’s
Simplex 21" Eminence NSW6021
1x20” THT
TLAH‘S
SLA Center-9 driver and Surrounds
SLA pros
TrT 10" Driver-10" Wide
Auto Tuba 10" Driver
Built:
2xDR300's
4xDual-30” Tuba 60’s
Simplex 21" Eminence NSW6021
1x20” THT
TLAH‘S
SLA Center-9 driver and Surrounds
SLA pros
TrT 10" Driver-10" Wide
Auto Tuba 10" Driver
- Bill Fitzmaurice
- Site Admin
- Posts: 28646
- Joined: Tue May 02, 2006 5:59 pm
Re: Plan Errors
Post it in the forum for the speaker, then we'll tell you why it's not an error.
It does happen, but usually is found and fixed within a fairly short period after the plans are released.
If you did email me I probably wouldn't see it anyway. Only personal emails get past the screening process. Besides, if there is an error that's something that should be known by everyone of interest.
It does happen, but usually is found and fixed within a fairly short period after the plans are released.
If you did email me I probably wouldn't see it anyway. Only personal emails get past the screening process. Besides, if there is an error that's something that should be known by everyone of interest.
Re: Plan Errors
10-4!
Thank You All for Your Time!!...Really!
Built:
2xDR300's
4xDual-30” Tuba 60’s
Simplex 21" Eminence NSW6021
1x20” THT
TLAH‘S
SLA Center-9 driver and Surrounds
SLA pros
TrT 10" Driver-10" Wide
Auto Tuba 10" Driver
Built:
2xDR300's
4xDual-30” Tuba 60’s
Simplex 21" Eminence NSW6021
1x20” THT
TLAH‘S
SLA Center-9 driver and Surrounds
SLA pros
TrT 10" Driver-10" Wide
Auto Tuba 10" Driver
-
- Posts: 599
- Joined: Fri Nov 13, 2015 9:34 pm
- Location: Vancouver BC & Bloomington IN
Re: Plan Errors
gotta say, plans are pretty darn accurate across the board. However, panel jig word doc, page 5. Illustration is correct, but plans say 2 x 19 inch end cap. Should be 2 x 10. Just in the spirit of continuous improvement
2xT30 (20", 3012LF)
2xT30 (21", 3012LF)
4xOtop J-array (Beta12, melded/straight piezos)
Truck Tuba (MCM)
Next up: 2xJack12 or family of table tubas
2xT30 (21", 3012LF)
4xOtop J-array (Beta12, melded/straight piezos)
Truck Tuba (MCM)
Next up: 2xJack12 or family of table tubas