I have read in old posts that at some point Mr. Fitzmaurice had a set of plans for speaker stands. Does anyone have a picture of them or the plans themselves? I understand there is liability with this subject and if no answer is the best answer, I am fine with that.
Thanks!
Speaker Stands
Speaker Stands
Thank You All for Your Time!!...Really!
Built:
2xDR300's
4xDual-30” Tuba 60’s
Simplex 21" Eminence NSW6021
1x20” THT
TLAH‘S
SLA Center-9 driver and Surrounds
SLA pros
TrT 10" Driver-10" Wide
Auto Tuba 10" Driver
Built:
2xDR300's
4xDual-30” Tuba 60’s
Simplex 21" Eminence NSW6021
1x20” THT
TLAH‘S
SLA Center-9 driver and Surrounds
SLA pros
TrT 10" Driver-10" Wide
Auto Tuba 10" Driver
Re: Speaker Stands
I had also looked for those again at one time, they where like two halfs that slid together.
2 - OTop8
2 - T39
8 - DR200
2 - DR250
9 - T24
6 - T45
1 - Auto Tuba
2 - T39
8 - DR200
2 - DR250
9 - T24
6 - T45
1 - Auto Tuba
Re: Speaker Stands
I found this quote in the forum (June 2012).
which was in answer to this question...Bill Fitzmaurice wrote: ↑Tue Jun 26, 2012 8:36 pm It was pulled as the stacking brackets in the latest DR revision made it obsolete.
djtrumptight wrote: ↑Tue Jun 26, 2012 5:29 pm can someone please post a link to Bills information on building stands for tops ? The ones with the trapezoidal shape ? I cant find it,thanks in advance.
TomS
-
- Posts: 1648
- Joined: Wed Mar 25, 2009 7:07 pm
- Location: Medicine Hat, Alberta, Canada
Re: Speaker Stands
I remember those, they were just like this table: Scroll down to where it says knock down table:
http://www.handyman.net.au/workbench-inspiration
Now make it taller and triangular so the top is the size of your speaker, but the bottom is wide. Add some cutouts for a ratchet tie down for your speakers, add cutouts to lighten it if that's your thing, then make it look pretty.
Can't see you making them any cheap than real ones though and they are adjustable.
http://www.handyman.net.au/workbench-inspiration
Now make it taller and triangular so the top is the size of your speaker, but the bottom is wide. Add some cutouts for a ratchet tie down for your speakers, add cutouts to lighten it if that's your thing, then make it look pretty.
Can't see you making them any cheap than real ones though and they are adjustable.
Built:
17" width 10" driver Autotuba
2 x 29" width dual Lab12 Tuba60
6 x DR250 2510/asd1001
In progress:
2 x DR250 2510/asd1001
For best results, point the loud end of the array towards the audience
17" width 10" driver Autotuba
2 x 29" width dual Lab12 Tuba60
6 x DR250 2510/asd1001
In progress:
2 x DR250 2510/asd1001
For best results, point the loud end of the array towards the audience