remove handles on iNUKE?
Posted: Mon Jun 27, 2016 7:47 am
Hi everyone
I've built my new effects rack and am very pleased. The handles on the iNUKE 3000 I have installed in the bottom of it stick out a bit further than I'd like and I'm considering taking them off, if this is possible. I have not popped the top off of the amp so I'm looking to people here who have done so.
Just fyi, I'm building a plexi face for this rack so that it keeps the front protected and clean (no worries about ventilation etc... got that all handled with positive pressure filtered air..
thx!
I've built my new effects rack and am very pleased. The handles on the iNUKE 3000 I have installed in the bottom of it stick out a bit further than I'd like and I'm considering taking them off, if this is possible. I have not popped the top off of the amp so I'm looking to people here who have done so.
Just fyi, I'm building a plexi face for this rack so that it keeps the front protected and clean (no worries about ventilation etc... got that all handled with positive pressure filtered air..
thx!