remove handles on iNUKE?

Is this amp OK?
Post Reply
Message
Author
northern piper
Posts: 33
Joined: Sun May 15, 2016 6:36 pm
Location: Muskoka Ontario

remove handles on iNUKE?

#1 Post by northern piper » Mon Jun 27, 2016 7:47 am

Hi everyone

I've built my new effects rack and am very pleased. The handles on the iNUKE 3000 I have installed in the bottom of it stick out a bit further than I'd like and I'm considering taking them off, if this is possible. I have not popped the top off of the amp so I'm looking to people here who have done so.

Just fyi, I'm building a plexi face for this rack so that it keeps the front protected and clean (no worries about ventilation etc... got that all handled with positive pressure filtered air..

thx!

88h88
Posts: 1562
Joined: Mon Jul 04, 2011 10:20 am
Location: Coventry, UK

Re: remove handles on iNUKE?

#2 Post by 88h88 » Mon Jun 27, 2016 7:56 am

They bolt in from inside the case on those so you'll need to take the top off. Bottom screws will no doubt be awkward because of this.
4xOT12s, 2xT39s@22", TTLS@18", 2xT60@18"

Post Reply