Crossover for OT-8
-
- Posts: 16
- Joined: Thu Oct 03, 2019 8:45 am
Crossover for OT-8
Hi guys. I am planing to build the Omnitop 8 X3 for LCR. Already got 6x D220Ti 1" and 6x Fane Sovereign 8-225 for drivers. My question is- will the pre built Dayton Audio XO2W-2K 2-Way Speaker Crossover 2,000 Hz work sufficiently as crossovers? Whath would be the difference compared to the diy crossover suggested in the plans, besides the steeper curves?
- Bill Fitzmaurice
- Site Admin
- Posts: 28646
- Joined: Tue May 02, 2006 5:59 pm
Re: Crossover for OT-8
No.Adrianmest wrote: ↑Fri Jan 21, 2022 2:04 pm will the pre built Dayton Audio XO2W-2K 2-Way Speaker Crossover 2,000 Hz work sufficiently as crossovers?
Re: Crossover for OT-8
I know it’s not pre built, but buying the parts for the right crossover from Leland would be the same price as that Dayton crossover
2 - OTop8
2 - T39
8 - DR200
2 - DR250
9 - T24
6 - T45
1 - Auto Tuba
2 - T39
8 - DR200
2 - DR250
9 - T24
6 - T45
1 - Auto Tuba
-
- Posts: 8319
- Joined: Fri Nov 27, 2009 11:37 am
- Location: New Braunfels, TX
Re: Crossover for OT-8
Just wondering.....why buy a driver that can operate much lower then the specified crossover point and pay a premium for it if you aren't going to use the ability of that driver? The ASD1001B is half the price and does what it's supposed to with the crossover in the plans.Adrianmest wrote: ↑Fri Jan 21, 2022 2:04 pm Hi guys. I am planing to build the Omnitop 8 X3 for LCR. Already got 6x D220Ti 1" and 6x Fane Sovereign 8-225 for drivers. My question is- will the pre built Dayton Audio XO2W-2K 2-Way Speaker Crossover 2,000 Hz work sufficiently as crossovers? Whath would be the difference compared to the diy crossover suggested in the plans, besides the steeper curves?
Also, that crossover you referenced will handle 4 ohms for the woofer, but the high pass is for 8 ohms. The OT8 has a 4 ohm tweeter section.
As suggested - get the parts and build the crossover or order one from Leland at Speakerhardware.com.
6 - T39 3012LF
4 - OT12 2512
1 - T24
1 - SLA Pro
2 - XF210
"A system with a few knobs set up by someone who knows what they are doing is always better than one with a lot of knobs set up by someone who doesn't."
-
- Posts: 16
- Joined: Thu Oct 03, 2019 8:45 am
Re: Crossover for OT-8
Good points. I will buy the designated crossovers for them. I already had 3 D220Ti so i bought 3 more.