4 25" lab12 loaded T39's and new PA+
-
- Posts: 560
- Joined: Sun Jan 28, 2007 6:32 am
- Location: ohio
4 25" lab12 loaded T39's and new PA+
Can anyone give me the ruff shake down of this unit with these subs. I am all ready setup at my venue and will have 250 people here at 5pm on Sat. I have my X-over figured out 40-100 24bd LW and 100-up to my B215D powered mains. But I have no idea how to set the limiter on this unit. PLEASE HELP.
Built
4-25" Lab12 loaded T39's
2-DR250's Melded array
2-DR250's Flat array
4-25" Lab12 loaded T39's
2-DR250's Melded array
2-DR250's Flat array
Re: 4 25" lab12 loaded T39's and new PA+
Is that the DRPA+?
I can't say exactly for sure, but...disconnect all cabs from the amps. Turn up amps full. Apply full signal from your board to your limiter. Adjust limiter so that the A.C. voltage coming out of the amps is below 50 volts for the T39. Also, read this http://www.dbxpro.com/forum/viewtopic.php?f=61&t=959
I can't say exactly for sure, but...disconnect all cabs from the amps. Turn up amps full. Apply full signal from your board to your limiter. Adjust limiter so that the A.C. voltage coming out of the amps is below 50 volts for the T39. Also, read this http://www.dbxpro.com/forum/viewtopic.php?f=61&t=959
TomS