FS and Qts for a TLAHPro

Short and Transmission Line Arrays for Pros
Post Reply
Message
Author
User avatar
Tom Smit
Posts: 7229
Joined: Sat Jan 05, 2008 1:24 pm
Location: Sarnia, Ont. Canada

FS and Qts for a TLAHPro

#1 Post by Tom Smit » Sun May 22, 2022 7:12 pm

I have often wondered if a driver, that I have in mind, would work good in such a cabinet, However, the Qts is around 0.3 whereas the Alpha8A is around 0.6, which is around the same spec for the Home TLAH. Also, the Fs is around 40 Hz for the driver that I was considering, and I was wondering how that would affect the performance. And, yes, I know this is going off reservation, gulp. :roll: I looked around on the internet for answers but the TLAH doesn't follow all the same rules as somewhat similar cabinets do, and, therefore, I am asking for explanations. :conf:
TomS

User avatar
Bill Fitzmaurice
Site Admin
Posts: 28018
Joined: Tue May 02, 2006 5:59 pm

Re: FS and Qts for a TLAHPro

#2 Post by Bill Fitzmaurice » Sun May 22, 2022 8:55 pm

Lower Qts along with lower Fs tend to cancel each other out, so they may work OK.

User avatar
Tom Smit
Posts: 7229
Joined: Sat Jan 05, 2008 1:24 pm
Location: Sarnia, Ont. Canada

Re: FS and Qts for a TLAHPro

#3 Post by Tom Smit » Sun May 22, 2022 9:52 pm

Awesome! Thanks Bill!
TomS

Post Reply