another grill question

High power and fidelity from an easy to build cabinet.
Post Reply
Posts: 348
Joined: Fri Nov 13, 2015 9:34 pm
Location: Bloomington IN

another grill question

#1 Post by himhimself » Tue May 28, 2019 2:24 pm

Anyone ever use something like this on the edges of your metal grill material? ... 7339&psc=1
I'm not quite there yet, but am thinking about the install on the j-arrays I'm building. I plan to make the straight front grills (at least I think), so making a little lip on the top and bottom isn't a problem. But figuring out exactly how to finish the sides where the horn sheaths round out is making me wonder. I thought maybe this edge trim would look nice, hide the rough edge, and let me screw it right to the sheath. My grill material has big holes that are offset, so when I cut it, it will not have a straight line of material.
2xT30 (20", 3012lf)
4xOtop Jarray

User avatar
Bill Fitzmaurice
Site Admin
Posts: 27228
Joined: Tue May 02, 2006 5:59 pm

Re: another grill question

#2 Post by Bill Fitzmaurice » Tue May 28, 2019 2:59 pm

I used it on my car A/C radiator grille, the lower one shown here:

I did it for the same reason, so there wouldn't be any jagged edges.

Post Reply