Crossover components
Crossover components
So I just bought separate components from Parts-Express 3 way Omni 12 Tallboy crossover, wanted to save money and do it myself. Any way I bought a copper 16 gauge wire from Michaels Craft store. Can I use this instead of speaker wire to connect components on the crossover board, then 18 gauge speaker wire to speaker drivers? Thanks
BaasssS, . . how low can you GO!
Re: Crossover components
What type of wire is it? Stranded copper looking stuff? Can you post a picture of it with an end stripped?
Build in process - 2 WH6, one Alpha 6a loaded, one PRV Audio 6MB250-NDY loaded
Two 2x6 shorty SLA Pro's
One T39, 16", 3012LF loaded
Tall AutoTuba, 20" wide, 2x 8" MCM 55-2421
TruckTuba, 8½" wide, 2x 8" MCM 55-2421
Two 2x6 shorty SLA Pro's
One T39, 16", 3012LF loaded
Tall AutoTuba, 20" wide, 2x 8" MCM 55-2421
TruckTuba, 8½" wide, 2x 8" MCM 55-2421
Re: Crossover components
No just a solid 16 gauge single copper wire wound semi soft solid copper thru.
BaasssS, . . how low can you GO!
Re: Crossover components
Just routing around to all the crossover components? I don't see a problem with that.
Build in process - 2 WH6, one Alpha 6a loaded, one PRV Audio 6MB250-NDY loaded
Two 2x6 shorty SLA Pro's
One T39, 16", 3012LF loaded
Tall AutoTuba, 20" wide, 2x 8" MCM 55-2421
TruckTuba, 8½" wide, 2x 8" MCM 55-2421
Two 2x6 shorty SLA Pro's
One T39, 16", 3012LF loaded
Tall AutoTuba, 20" wide, 2x 8" MCM 55-2421
TruckTuba, 8½" wide, 2x 8" MCM 55-2421