The sales/information page says the T45 has similar response to a T30. Reading through the plans, the voltage limit for the Delta 12LFA is 5 volts higher in the T30. I assume this indicates that the driver reaches the same displacement on less voltage in the T45. Which, if true, I kinda like.
The T30 design is able to take advantage of the benefits of V-plating. To me, I see this as a possible indication that this driver is potentially capable of more peak output in 4 V-plated T30's than in 4 T45's. True?
Also, the max width's are different. 30" max for the T30 vs. 24" max for the T45. I'm not quite sure what to make of that information. Is the max width response also similar, or is it more similar on an inch for inch basis and the wider T30 has additional sensitivity?
Which design would have the advantage in maximum output potential, assuming each at a width of 24" and the T30's being V-plated? What about at max widths?
Thanks a bunch