T24 Slim - interior panel width

Get the lowdown on the down low.
Post Reply
Message
Author
User avatar
J_Dunavin
Posts: 947
Joined: Sun Jul 09, 2006 3:13 pm
Location: Appleton WI

T24 Slim - interior panel width

#1 Post by J_Dunavin » Thu Jul 12, 2018 10:22 pm

I know that the minimum width for the T24 is 16", which i would think would make all the interior pieces 15", but the plans call for 15.75" width interior. Is that just a typo, or is 16.75 the real min width?
6 - DR200
2 - DR250
9 - T24
6 - T45
1 - Auto Tuba

User avatar
Tom Smit
Posts: 6591
Joined: Sat Jan 05, 2008 1:24 pm
Location: Sarnia, Ont. Canada

Re: T24 Slim - interior panel width

#2 Post by Tom Smit » Thu Jul 12, 2018 11:46 pm

I searched through the different versions of plans for the T24, and finally found the 15.75" in the original plan. The idea is that the panels are initially cut to this width (not Length), and later when each panel is to be installed, it is cut to the final dimensions (of which would be the 15" internal width).
TomS

User avatar
Bill Fitzmaurice
Site Admin
Posts: 26415
Joined: Tue May 02, 2006 5:59 pm

Re: T24 Slim - interior panel width

#3 Post by Bill Fitzmaurice » Fri Jul 13, 2018 6:51 am

Correct, and the reason for 15.75" rather than 16" is to allow for the width of the saw cut when you're cutting three panel sets from a 48" wide plywood sheet.

Post Reply