BillFitzmaurice.info

Hello all,
I have a behringer 1002B mixer. I use it to do a little karaoke and I was wanting to add some effects like reverb. What options do I have? Or do I need to replace it with one that has effects built in.

Thanks in advance,

Oscar

Thank you all for the replies I appreciate the help.

O

Hello rotebass, Yes, the reason I need to run it overhead is due to there being a high traffic area between the place where I setup and the speaker location. After the parade starts and everyone is seated it would not be a problem, but we have to setup early and I find it better to get it up out of ...

There may have been a sharp edge, but it was mainly tears where the wire was pulled and streached. I will look into ProGrade wire. If it is not too costly. If it is I just thought of running a guide rope and then zip tie the cable to it.

Thank you Frederic for the quick reply,

Oscar

Hello all, Last year I setup my small PA to MC a parade. I had to run one of the speaker wires overhead about 25'. After I noticed that the rubber sheath had ripped in a few places. The wire was still ok so I just repaired it with electrical tape and it was still functional. I don't my wire will las...

Just received a reply from GTD Audio. XLR outputs are mic level. So that explains the low input level into the Mixer. Will be changing 1/4" TRS for XLR.

thanks for all your help,

Oscar

Thanks for the reply bruce, The wireless receiver has two XLR individual outputs and one 1/4" Mixed output. I just found this: "Microphone level is generally significantly lower than line level. Depending upon the microphone and the sound pressure level (SPL) injected into the microphone, ...

Hello all, I am using a XENYX 1002B Mixer for my at home Kareoke with a set of GTD Audio G-788 wireless mics. I made up some wires with XLR from the wireless receiver and 1/4" to the channel mono on the mixer. I have noticed that the mics have to be turned up past 0 in order to keep up with the...

That is exactly what I was looking for but I wasn't sure about the 1U 2U spacing. I will check out those cases from musicians friend. Thanks a mil.

Hello guys, I am looking for a case to install the components of my PA. Am tired of unpacking them repackinh everything when I setup my system. I want something that I will hold my amp crown xti 1000, driverack px, wireless mikes and xenyx 1002B mixer. Is there a case available that will hold these ...

Bill,
Just finished the book on kindle. Great read. Enjoyed it very much. Thanks. any other books in the pipeline?

Oscar

Hello all, A friend showed me some boom boxes he built out of an ice chest, radio and speakers, powered by a 12v batt. I looked online and there are tons of different ways to people are making these. So I thought to my self, I can build one of these easy. But then I kept thinking: 1. Should I build ...

A 5000 watt generator should be able to run 41 amps. watts / volts = amp. The XTI 4000 draws 10.5 amps, Mackie's show 300 watts= 2.5 amps each. If your generator was not able to run all of them then I think your genset may have some issues. I would try another genset. Look up the specs on your gear ...