BillFitzmaurice.info

Good link thanks! I'm reading conflicting information on sub configuration and placement - whether to couple 2 THTs in one place or spread them out for coverage and smoothing response. Personally I'm getting sufficient dB output from the single finished sub, and would prefer if I can make separate p...

Thanks Radian! Working on the multimeter, and I didn't see anything questionable in the inuke. Driver seal is good. Thanks for the tips! Ill post voltage as soon as I get it. Can somebody enlighten me on the best initial corner alignment for a THT if corner loading is the goal? I've read against one...

This birch ply mics out to .485, if the thickness of a piece of cardstock is enough to throw off response appreciably, count me surprised. I appreciate the concern for absolute accuracy in printing out the plans though, and if this was a jet engine I'm sure I'd be a little more precise. Using the pl...

Haha, I did. Rather than measuring and plotting out points on both square sides (I'm mirroring the second sub) I printed out the schematic at 100%. I cut out the intersections of the panels so I could use it as a stencil, then connected the lines to show me exactly how the panels should lay out. I f...

This has made me curious. What "event"? Ah, nothing grand. Just a scheduled movie night at my place that snuck up on me and which I couldn't bear to A:cancel or B: conduct sub-less! I'd already sold my two bag end Infrasub-18's to fund these! A personality flaw maybe :noob: I have the RSS...

Here are two THTs I'm working on, I ended up getting pressed for time to make an event date and had to focus on one rather than building them simultaneously. I started with all the rough cuts for both per the cutlist in the instructions. Protip: I naively discovered the included cutlist with the ins...

Hi everyone, I can't say exactly how I ended up here except for some quibbles with my current sub solution... I must have been reading a theater build thread and been pointed to Bill's designs. Anyway, I've got plans and currently in the 'ordering stuff' phase for 2 Tuba HTs. I've been into AV equip...