BillFitzmaurice.info

Hey buddy we should hookup I'm in Miami also send me email with contact info and we will go from there. Welcome aboard.

Never mind got my answer from a sound engineer not someone hanging in forums comparing sizes. Anyhow got a straight up answer from someone that knows what they're talking about.

Ok let's try again I replaced my old DoD 834 crossover which by the way is very simplistic crossover. On it I had three knobs and a gain per side. Well it started acting up so I replaced it with a behring cx3400 crossover and everything I'm used to seeing except the delay knob and time threshold kno...

I have 2 18" peavy black widows in vega style box 2,5inch with a horn as drivers for mids and 8 piezo for high I want to have the crossovers frequency set correctly my set is indoors at the moment

I have a 3 way setup 3 amps need to know about multiband limiter and delay how and why do I set those please I need a preset config to set mine properly

Thank you all for the great feedback I finally broke them in my multimeter would not measure voltage until I put red on red and black on amp chassis. Thank you very much guys ill be checking for leaks tomorrow . Now would a shop vac hose work for that.i hope so

Sorry guys I'm sorry if I come off as a blonde but the only dumb questions are those never asked better to be safe than sorry these drivers were a pretty penny and I'm not trying to blow them So here I am tell me if I'm right or wrong my 30 hz mp3 is ready to go do I buy pass my crossover and eq set...

Ok here's where I'm confused I went online and downloaded a 30hz mp3 it's basically not even audible except when the looped recording starts again. Now what do I do I got a jack from my ipad to my line input in mixer now what do I do please explain step by step for me I'm really anxious to break the...

Ok I thought tone generator was a program or is it an electrical tool because I own multimeter but not a tone generator

I didn't finish putting upper brace because Bill warned about it being hard to mount driver if I would of so even though you didn't really answer my question you repeated what Bill's instructions said. I'm looking for someone to word it different " how do I check for leaks maybe a pic or two wi...

Ok so I'm waiting for my drivers to be delivered I understand before I mount them I need to play a tone thru them 25 thru 30 htz at 10 volts so i guess i put multimeter to terminals and pump up the volume till i get that voltage and leave it there for 12 hrs. Then its time to check for leaks is ther...

Ok there's a couple questions I've been meaning to ask. I'm at 90% percent done with my T48 first build and I'm proud so far of the outcome I'd thought I'd mess it up somehow. Here are the things I did wrong I didn't cut the notches for handles or the caster cut outs I'm waiting for my drivers to be...

Never mind the answer was there for me on the precut pieces I have according to plans it says on the outside and based on my panel sizes it checked out thanks bro for trying to help

On a titan 48 I'm a bit confused on drawing the 1/2 inch lines . Do I draw them to the right of the original lines which don't alter the original measurements or are they drawn to the left of the original line which means a more narrow mouth?

Ok I'm wondering three things one why do my titan's 48 plans have access panel in front and every single titan I've had the chance to look at,has it on top???. Any my next question is, is it necessary to put nut & screw for every hole of the driver???. And last thing is how many screws should I ...