BillFitzmaurice.info

Their store locator does not even show Chesterfield yet, I live in Howell, zip 48843, and no store on the map... Arauco: cheaper and lighter; admittedly not as good as BB but I'm going for cheap and light. I don't need touring quality cabinets. My Arauco definitely has a bit of warp to it, though i...

Menards shows Arauco in stock in 1/4, 1/2, 3/4 at the new Chesterfield location. It's getting easier and cheaper to build those cabs now! w00t!

Right, if you worked at a tool supplier it'd be the left handed crescent wrench, the pipe straightener... oh, and you forgot about the blinker fluid.

From most of these drivers, impedance plots can be found online. My measurements pretty much match the online plots. Good :cowboy: Note from the plots above that the peak in the impedance plots happens more or less at fs (resonance frequency) from the driver specs. The little HiVi driver is a bit o...

You can do this with REW (free) also using the same sound card jig mentioned. I just built a similar jig, though I used a 50 ohm sense resistor as it sounded to me like it's more sensitive that way per the article (linked later). The basic schematic is in REW help, but there's a bit more extensive w...

Yes, thank you much DJPhatman. This is a significant amount of help, very timely as I have just begun getting serious about some builds.

I was looking into this recently too, the guy at Plywood Detroit (in Warren) told me they carry Baltic Birch 4x8, quoted grade "4B", 1/2 inch is $42.35 per sheet. I haven't gone to see whether the stuff is equal-ply / veneered / full of unfilled knots both sides etc. If you believe the web...