BillFitzmaurice.info

I'm not clear on the suggested handle hole size for the Titan 39...

As stated in the instructions...
"The easiest way to cut hand holds is to drill two 1½ inch holes four inches apart on-center"

So my question is... Is this correct? (as noted in the attached picture)

I looked at my measurements again. The baffle hole is only off center by 1/8 of an inch (towards the top). When i set the driver space down and leave required 9/16 spacing the hole is off center to the ring by the measurements noted in my previous post.. So should I assume that the baffle hole shoul...

I'm working on my pair of Titan 39's with 12" speaker. I screwed up a measurement and need to know if I need to redo it or if it is OK the way it is. The rectangle hole that I cut in the baffle board is a little off center. From the top of the baffle hole to the top inside of the driver space i...

Oh! My bad.. I guess I should have said BEVEL instead of angle.. I am a bit OCD and I want things to be just right.. I have done a lot of remodeling in the house. I just gutted the kitchen in January overhauled everything including electrical and pluming. I try to make my goal "perfection"...

Among the million other things I have going on I am doing some reading and research in preparation to my Titan 39 build. What is the best way to dial in the correct (and accurate) miter angle? I have seen these tools online but wanted some expert opinions. :clap: Grizzly G2858 Table Saw Gauge http:/...

I have questions regarding the comparison between the DR200 and DR250 but I will post a message in the DR forum instead of here..

I haven't bought my plans YET.. I don't want to second guess myself after I have already purchased them..

Hello everyone. I have been browsing the forum for about a week now and decided to sign up and build some speakers. I have been playing in small club bands for years but recently left the band I was in to take a break. In the mean time I and going to build some new speakers. I have decided on the Ti...