BillFitzmaurice.info

Tom Smit wrote: ↑Tue Feb 10, 2026 10:34 pm Welcome back!
Do I read that right? You are building 4 of 30" T60s?

I did way back in the day, but never ran all of them. Just had 4 lab 12's at most back then. I sold them as a lot to someone i don't remember who scooped them

Man i've been off of this stuff for years. I was going through my "memories" tote, and found all of my binders with plans for all the stuff i've built. they've got the oozing pl premium smudges on them and all! I started building BFM horns as a freshman in highschool, I was a young dj. Los...

I am the dj and it was awesome!

As far as progress not much has been made. I just need to put the sides on the last two and the braces.

Hey sorry guys I haven't been posting, Grandma came into town, I used her garage to build these so I needed to consolidate so her car could fit in the garage. Setup is Lighting- 4 Roboscan 812s, 2 ADJ megaflash dmx and a spencers laser. Ran with freestyler off of a laptop Sound- 2 20" t60 singl...

They are Chinese rip offs, but they are not cheaply built. There have been extensive testing along with a large thread on these particular amps. And yes I could run them at 8 ohms that was a brain fart on my part. I would run the 200s with the top 4 wired parallel-series, then the bottom two paralle...

I am looking at a Lab Gruppen clone FP10000Q amp, and its rated at 1350w @ 8 ohms per channel, 4 channels total and 2x 5000 watts bridged @ 4 ohms. That nets me 2x183v of power, meaning I could run 4 16 ohm T60 duallies off of one bridge, and 6 Dr200s off of the other 2 non bridge in a 30lb 2u amp. ...

Yea I lift them in my van no problem by myself
Gig pix later

Day 8, Got one loaded for the homecoming gig this weekend. I was hoping to get two done, but I didn't want to tear apart my subs and not get it finished and not have those two for tomorrow. I will post gig pics, as I have some cool stuff to show off :P https://fbcdn-sphotos-h-a.akamaihd.net/hphotos-...

Sure, 11 inches is the difference, that and better workmanship.

Day 7, Almost got all the final braces fabbed, They are all cut out I just need to round the edges over. The access panel flanges are in place, and unfortunately I wont be able to install t nuts due to the baffle panel being in the way in the back. Sad feels. Screws it is then. Hoping to get all bra...

Nope they are crooked. I thought it might give the cabs an abstract, hipsterish look

Day 6, No pics, but just try to use your imagination :mrgreen: . I got all the pl squeeze out out of the mouth, and put the two cross braces in. I put the back two reflectors in too. For the empty cavity by the driver chamber in the middle; I added a panel before the sharp corner, mainly for cleanli...

Does anyone have any tips to scrape squeeze-out? I should have edged the squeeze-out when it was wet for the mouth braces it's really hard to get out, even with the side off. I'm using a stiff chisel and hammer, going with the bead, against the bead and it's just taking forever.

I never use a tablesaw. All circular and routers. Tablesaws take too long . The last 3 hours were assembly, only danger is the brad nailer. No progress today, i needed to wait a full day for curing. I need to sand down and form pl so it needs to be dry dry.