BillFitzmaurice.info

That's the thing... I am trying to find out if I am pushing them "that hard". If I have my limit set very low, there is no sense in more cabs if what I have will handle what I need. I hope Bill does comment here. I think I have a legitimate question. The plans state what a safe limit shoul...

Hi all... It's been a while since I have been here. I must say that I am very pleased with my BP102 loaded T39's. They have exceeded my expectations! I wanted to bump this thread because I never was able to find a solid answer for this... being, what would my voltage limit be for the BP102-4? I just...

... Reduce the limiter threshold until the AC voltage is that which is specificed in the plans for your cab and driver.... I am using BP102 4 ohm speakers in my T39s. The plans state the max voltage for the BP102 is 35 volts, but I am assuming that is for 8 ohm speakers? Can someone tell me if I am...

And kickinit, we're just having some fun at your expense. Don't mind us. :ugeek: Although.... once you get the T39s up and going, you know you're going to want some DRs to replace those Mackies.... No worries :) Fortunately ( :? huh) I am in a band with not enough following to justify a 2nd row... ...

If you will allow me to revive this thread... I too just picked up a DCX2496 for my system. Might one of you good folks suggest what settings to use to configure the limiter? My system is on the smaller side... I have 2 powered Mackie speakers to be used as tops (mids/highs), 2 T39s with a single BP...