BillFitzmaurice.info

Why wouldn’t I be able to high pass the low side for the T39? The XLS series amps have the ability to set a variable band pass crossover or a high pass or low pass on each channel. Unless they have made a major change to the software in the XLS (I have several and have used 'em for a decade), you c...

double post

Thinking about it though I may be better off building a T39. With the XLS amp I can set a separate high/low pass crossover to each channel and could run the T39 and the 210. I think this would be a smarter move. A Jack 15 is pretty unwieldy.....I know, I built one. Much easier to roll a T39 than to...

Interested in the DR200s, and if the T39 sale goes through those as well Thanks for your interest. I tried to PM you, but for some reason my messages are just getting saved in the “outbox” folder but not sending. Can you PM me your email address so we can communicate that way? Thanks! Your inbox ma...

I'm not quite understand but will try this tomorrow BTW the plate amp fit perfect at the side of the Jack. Thanks Henry Are you going to attach a box to the outside of the Jack to hold the amp? I don't see any way you could fit that inside the cab with the Horn braces and the Flanges...and the amp ...

Hello member I just build a pair of jack 10 how do I wire this plate amp to the crossover from speaker hardware ? . According to Mr: Bill (4 pole Speakon on the cab containing the amp and one on the extension speaker ) any diagram would Appreciated Thanks If you already have the Jacks loaded with t...

Great to see you post again. How do you leave the music business? I'm pretty sure I'm in for life whether I like it or not..... :mrgreen: Good to see a familiar name pop up again! Hope you’re doing well! I think it would be fair to say that I’m leaving it, but it’s not leaving me. For me, it’s alwa...

Great to see you post again. How do you leave the music business? I'm pretty sure I'm in for life whether I like it or not.....

Tom Smit wrote: ↑Mon Jun 23, 2025 9:45 pm viewtopic.php?t=26508

Mike D has been notified....

Joman116 wrote: ↑Sat Jun 21, 2025 11:36 pm Hey Bruce, any of this still available?

Not sure. I just sent him an email.

T_Gowan wrote: ↑Fri Jun 13, 2025 9:51 am Any one have experience with Crown XLS2502? Good, Bad? See one available locally and wondering if I should pursue it.
Thanks.

Been using one for 10 years with no problem. Put one in a local venue for subs probably 5 years ago - gets used 5 days a week. No problems.

+1 To everything that Seth said. Especially about building T39s instead of T24s.....I have both.

Bill Fitzmaurice wrote: ↑Sat Jun 07, 2025 4:01 pm No measurable difference either, so long as the bottom of the cab is less than 1/4 wavelength from the ground. At 100Hz that's 85 Cm.

But, won't gravity make all the sound fall to the bottom of the cab?

Just thinking ahead. What radius can you do on the edges of 1/4 inch material on Lite boxes. And are there stackable corners that work on these? Probably be hard to find corners for 1/4". But, what you could do is put a 1/4" plate on the outside surfaces where the corners go (say 2"x...

I use imgur to post pics on forums. It doesn't shrink them down or require it to be potato quality from the dial-up age. The forum went through a change a few years ago that allows larger files now. Yeah, it was pretty grainy when you had to re-size everything to get it to take......but, not any mo...