BillFitzmaurice.info

Hey Prior, welcome to the forum and thank you for sharing your success. I've gotta say, your cab building experience really shows through in your execution of these cabs. Well done my friend. :thumbsup: And, while it's difficult to see the full venue in the photos shown, it seems you brought militar...

Grant Bunter wrote: ↑Mon Oct 02, 2023 9:53 pm https://www.greatguitareshop.com/sell-5 ... hragm.html

China telephone number. Interesting site. Have you used them before?

Is it me, or do I spy a Dayton Audio KABD-4100 in there too? Or, is that the Sure?

...Sometimes, you have a complete coil but DC resistance is not near zero, but is less than the lowest rated nominal load of the amplifier channel. In which case it will go to protect. Rarely, you can measure a very low impedance, say 1 ohm, and many amps will identify that as a dead short and go t...

...I am ready to just buy a new tweeter and cap but I don't like throwing parts at stuff. Any ideas?... I took the time to follow up on some of this. Looking at the ratings for the APT-80 tweeter you have, it's rated 45 watts when crossed over at 3.5 kHz, 18 dB/octave and 85 watts if crossed over a...

Bruce Weldy wrote: ↑Wed Sep 27, 2023 4:43 pm Because I'm too lazy to dig back through 250 posts.......what is the mixer/amp configuration?

Dayton Audio KABD-4100 4 x 100W All-in-one Amplifier Board with DSP and Bluetooth 5.0 aptX HD

CarterKraft wrote: ↑Wed Sep 27, 2023 2:08 pm

Seth wrote: ↑Wed Sep 27, 2023 12:13 pm Weldon, do you have any compressors or limiters in your DSP signal flow path?

No I didn't the only DSP I had in there was the dynamic bass module on the woofer.

But I got rid of all that stuff when I made the from scratch tune, only crossovers.

That rules out limiter pumping.

This "clipping" effects the low and mid but if I mute in software or just disconnect the tweeter it doesn't clip. I am thinking the tweeter is busted and is shorting somehow? Sounds that way from my own explanation. It does seem to point this direction. Are you able to disconnect the twee...

Weldon, do you have any compressors or limiters in your DSP signal flow path?

There's a thread or two floating around from years ago about a 6" loaded "DR150". IIRC, they got built and tested for home theater duty. I don't recall the outcome. I'll see if I can use my google foo to find the thread for you a little later.

Ha! You've got me genuinely chuckling over here. Too funny.

Hahaha, that's hilarious Bruce.

Now you can skip through the living room in your underwear while riding your stick horse all you like. You've got it made my man.

Congratulations!

Reading along with a big shit eating grin on my face, trying to contain the emotions welling up from within, like the final hero scene of a Disney film. When, as a man, you don't want anyone else in the room/theater to know your emotions have been stirred the least... and a little something escapes ...

Howie, I don't think I remember you saying what driver you ended up going with for the T24's. What drivers are in there?