BillFitzmaurice.info

fender3x wrote:
I haven't found one of those for a 1/4" collette. Where did you find yours?

Try Lowe's I got one there or a local wood worker supply store. Like Woodworkers Source or Woodcrafters.

If you have a 1/4" shank bit you probably taking too large a cut. I usually take 2 or 3 passes with a bearing over bit. If the bearing is under the bit, I use a jig saw to cut within 1/8 to 1/4" from line then finish the cut with the router. If 1/2" shank go slower probably. What make...

Try here. http://www.madisound.com/

To adjust a framing square you use a center punch, on the flat side near the outside of the the corner, if it's too wide, or on the inside part if it's too narrow. This usually requires several hard whacks with Frankenspeakers big hammer. Two or three separate spots usually gets the job done. Droppi...