BillFitzmaurice.info

Thanks Bruce for quick reply, I just wondering if the bass spl is much better in the rear when elevated than on the ground because people blocked the sub and i am afraid that the rear had very low spl.

Is it okay to elevate my standing 4 titan39 30" to 6 ft above the dance floor, reason is that the venue an outdoor basketball court is full of people, I don't want to add subwoofer since its very rare to have this large crowd.

Thank you guys your big help. Happy New Year.

Someone change my crossover point, disabled my limiter and resulting to 3 titan39 lab12 defective. I had only 1 t39 left working. I forget the crossover settings on midrange and high frequency. I use bunker bpd1 processor active with an 1 amplifier for sub, 1 amp for deltalite 2512, 1 amp for asd100...

To both DJs and SE: How much distance you position yourself from your booth to your speakers? Any one like to share? thanks in advance.

Thanks everybody answering my questions, nice to be here in this forum.

Ideal lenght of cable will be short as possible to minimize loss of signal and cost, but there are times you need more on other venues. In real world what is the most common length of cable use here.

Minimum cable lenght from speaker to amp to avoid issues of cancellation on certain frequency between left and right speaker.
.

I am not daisy chaining...as of now i have only 2tops and 4 subs vplated. in the future maybe.. I plan to buy a new cable to replace my temporary short and and limited cable. I forgot the minimum separation of speaker when splitting top and sub into left right stereo. I dont know what is the common ...

Please advice me the typical and minimum length of cables when splitting tops and subs for DJ and for Live Band use. I usually split tops but not subs but it is nice to know. Thanks

Sorry for my math!
ASD 1001 is 50w 8 ohms connected in series with another ASD1001 on DR cab1. DR cab2 has same config as DR cab1.
DR cab1 & DR cab2 are connected in parallel to my amplifier Channel B. On this setup how much maximum volt i would allow on my limiter.
Thanks

sorry it was a typo.

On another hand how much voltage should i set on my limiter on asd1001on series configuration.

thanks Bruce for the info, iam using bunker spkr dsp.

A single lab12 is limited to 59v for t39 2 paralell lab 12 in one channel how much voltage i set for my limiter. A single deltalite 2512 is limited to ? voltage in dr280 2 parallell dr280 on one channel with deltalite how much voltage limit? 2 compression cd AS1001wired per plan on my dr280,,,how mu...

I had seen your led build escapemcp. its nice to have a light like yours good luck to your next project, can you share me your project design. About the 50w led, i am interested building a 50w rgb par lights. I am looking a diy kit at the amazon but i didnt find it it yet.