BillFitzmaurice.info

Hello all. I am looking into adding a Driverack (more than likely the PA2) to my setup. I was curious about the autoEQ - have any of you had issues setting this up outside (wind, excessive background noise, etc.?) as well as inside. I do understand that the quieter the better, but as we all know, ma...

Have not been on here for a bit, but will address a couple of points mentioned. *No sister, been asked that many times. :) *Hopefully her willingness to help daddy in the garage will continue, we shall see. She is quite a good little helper. Though my wife appreciates the build process and the end r...

Dan30 wrote:Looks sexy, and the cabinet isn't bad either.

thanks..! The pic of the helper is a tad deceiving until you really look at her size compared to the cabinet..... and note the Barbie Jeep in one of the other pics.

Congratulations on your build! Looks nice. Now you need at least three more! That is the plan. I already have 2 of these that were built by an authorized builder, and when I bought my Baltic Birch I purchased enough to do another, will be starting on it as soon as the next stretch of days off comes...

A few pics from my first build - will post more later as well.

I appreciate the feedback! Thank you for the help. I am sure I will have plenty more questions over the next few months as I grow.

So after much "I will build more when I have time" debate with myself, I have finally decided that this fall/winter project will be taking my system to the next level. I currently run 2 x T48s on a Behringer EP2500, which I have been pleased with but want to add 2 more 48s. The plan is to ...

I have used my T 48's for the second time now with a full band, the first was in a smaller church (seating around 100), so there was plenty of bass on reserve. Saturday night was in a much larger venue, which seats 350+, high ceilings (30'), and large openings into the foyer area (about 80' from the...

Thanks for the replies and info. Chris, I am located in South Central Kentucky.

I have seen various cabinets with the metal mesh grilles (smaller holes, not the round waffle style) - where can I find this material, and what is the best method to put it on and avoid rattles (if that is possible) Thanks.