Search found 1229 matches

by BrentEvans
Mon Oct 15, 2018 3:06 pm
Forum: Amps
Topic: On Board Amp
Replies: 4
Views: 92

Re: On Board Amp

Not to mention it has two amps on board, making a biamped cab possible.
by BrentEvans
Mon Oct 15, 2018 3:02 pm
Forum: Everything Else
Topic: Do voltage limits change with cabinet design?
Replies: 10
Views: 195

Re: Do voltage limits change with cabinet design?

when they break up, it’s so nasty no one in their right mind would keep going. My assumption is that the responsible culprits are teenagers, which explains that. :noob: Well... I hooked them up to my IPR7500 sub amps once to see how much they could take... they took it all until I was hard into the...
by BrentEvans
Mon Oct 15, 2018 1:58 pm
Forum: Everything Else
Topic: Do voltage limits change with cabinet design?
Replies: 10
Views: 195

Re: Do voltage limits change with cabinet design?

Yeah, that's pretty funny right there Brent (but expensive!) I do like my little portable rechargeable-battery Bose bluetooth speaker though. It comes in handy. The sound isolating headphones are also nice for drowning people out (and for checking rough audio levels coming from streaming services i...
by BrentEvans
Sun Oct 14, 2018 10:57 am
Forum: Everything Else
Topic: Do voltage limits change with cabinet design?
Replies: 10
Views: 195

Re: Do voltage limits change with cabinet design?

Unless you're the one operating them limiting will do you no good, the people using them will find a way to change it. Never loan or rent out anything you won't mind getting back broken. Or, they’ll keep turning everything up that makes it “louder” and run the whole thing into clip for so long it b...
by BrentEvans
Tue Oct 09, 2018 1:08 pm
Forum: Everything Else
Topic: Kitchen cabinets
Replies: 6
Views: 211

Re: Kitchen cabinets

I sent it to the guy that builds my speakers and is currently building my kitchen cabinets. He said he was going to frame it.
by BrentEvans
Wed Oct 03, 2018 2:51 am
Forum: Everything Else
Topic: Lab 12 recone kits
Replies: 22
Views: 333

Re: Lab 12 recone kits

Interesting. Thanks for the explanation CO. I didn't know there was such a thing as an RMS Limiter and must have mixed the two up somewhere along the line. Now I'm wanting to see the waveform of a limited signal on an oscilloscope. Why would they not just have it work the same as a compressor w/o m...
by BrentEvans
Wed Oct 03, 2018 2:46 am
Forum: Everything Else
Topic: Lab 12 recone kits
Replies: 22
Views: 333

Re: Lab 12 recone kits

When these idiots start redlining gear (which includes playing hard into the limiter so it's always limiting), they start driving the power curve up so you end up getting more power per volt. I thought limiters left the signal intact. Like compression, attenuates signal peaks. No? Normally not. Com...
by BrentEvans
Mon Oct 01, 2018 9:34 pm
Forum: Everything Else
Topic: Lab 12 recone kits
Replies: 22
Views: 333

Re: Lab 12 recone kits

EDM DJ's never have enough. I since wired them series so that even if they disable the limiters: A: only 1 would blow instead of both at once as that would open up the circuit (they are dual loaded cabs). B: the amplifier only puts out 97 volts so each driver is only seeing around 48.5 volts - with...
by BrentEvans
Mon Sep 03, 2018 9:51 am
Forum: Pro Sound Setup
Topic: Typical Gig house mains combination
Replies: 11
Views: 206

Re: Typical Gig house mains combination

In room sub placement is always a bit of a boondoggle. There are always compromises between room design, available space, permissions, etc. Split subs on either side of a stage is almost always the last resort, unless the stage is 50 feet wide. There is a very valid reason this is done by “everyone ...
by BrentEvans
Sun Sep 02, 2018 6:59 pm
Forum: Pro Sound Setup
Topic: Typical Gig house mains combination
Replies: 11
Views: 206

Re: Typical Gig house mains combination

Since you Already have the JL12s, just add another pair of those. You aren’t losing much over the OT12s, and add a pair of wide t39s. Don’t split the subs though... follow the sub placement guidelines
by BrentEvans
Sun Sep 02, 2018 12:30 pm
Forum: Tuba and Titan Pro-Sound Subwoofers
Topic: T60 Limit
Replies: 92
Views: 1296

Re: T60 Limit

All I said to do was test your assumptions and assertions. Apparently your intelligence is simply easy to insult. A good scientist asks a question that assumes nothing. then finds a way to answer that question without bias. This question is a matter of science, not opinion. If you want evidence, the...
by BrentEvans
Wed Aug 29, 2018 10:21 am
Forum: Tuba and Titan Pro-Sound Subwoofers
Topic: T60 Limit
Replies: 92
Views: 1296

Re: T60 Limit

Not making any assumptions. I hear what I hear. You couldn't convince me the dog I'm looking at is a cat just because you're a veterinarian. Cheers. Respectfully, you are indeed making assumptions. You are assuming that you have heard true content in these frequency ranges, and that you know what i...
by BrentEvans
Wed Aug 22, 2018 8:54 am
Forum: Omni Bass/Key/PA Speakers
Topic: Dayton driver for OTop?
Replies: 8
Views: 403

Re: Dayton driver for OTop?

They look like a competitor to the delta pro12-450a more than the beta. While they don’t have the rising response, sensitivity below 1k is in the ballpark, and they have more power handling and comparable Xmax. Other specs are not identical, but that would be a function of cab design. In a purpose d...
by BrentEvans
Sun Aug 05, 2018 10:36 am
Forum: Everything Else
Topic: Looking for WAF on wall plates
Replies: 5
Views: 252

Re: Looking for WAF on wall plates

https://www.parts-express.com/wired-home-wpi-51hd-51-channel-with-hdmi-component-wall-plate--300-617 You can build any combo you want with decora inserts and keystones, though. This company is local to me, have been using their stuff for years with no problems. https://www.firefold.com/home-theater/...
by BrentEvans
Sat Aug 04, 2018 1:57 pm
Forum: Everything Else
Topic: Looking for WAF on wall plates
Replies: 5
Views: 252

Re: Looking for WAF on wall plates

Speakon is a bit much for home Theater. Banana terminals or binding posts are more than sufficient.

https://www.parts-express.com/audtek-el ... t--261-352