I was bored and have access to a 3D printer, so I 3D printed a T48 for fun. It's roughly 19% of a normal size slim T48 and uses a Cambridge Soundworks 2.5" driver from a cube speaker with unknown specs. I used plexiglass for the side and access cover. All I had laying around was automotive RTV sealant, but I'll probably re-do it with epoxy or something more permanent.
If my numbers are right, the shortened horn length puts the tuning at around 160hz, so I guess it's more of a mid-bass cabinet now.

Anyway, here are the pics.




Nothing scientific on this test. Measurement mic is a foot away from the mouth sitting on the table.
