8 x DR250 build

Post your build odyssey here.
Message
Author
CoronaOperator
Posts: 1648
Joined: Wed Mar 25, 2009 7:07 pm
Location: Medicine Hat, Alberta, Canada

Re: 8 x DR250 build

#136 Post by CoronaOperator »

should be fixed now
Built:
17" width 10" driver Autotuba
2 x 29" width dual Lab12 Tuba60
6 x DR250 2510/asd1001
In progress:
2 x DR250 2510/asd1001
For best results, point the loud end of the array towards the audience

Bruce Weldy
Posts: 8301
Joined: Fri Nov 27, 2009 11:37 am
Location: New Braunfels, TX

Re: 8 x DR250 build

#137 Post by Bruce Weldy »

CoronaOperator wrote: My amp rack for this room used to weigh over 100 lbs and just the sub amp alone would trip the breaker for that outlet. Everything is on one 15 amp breaker for this setup and output levels that have no problem exceeding 130 dBC.

And you should still have some room left....

I run 6 subs, 4 tops, and 6 monitor mixes (7 Crowns/3 Driveracks/mixer/fan) off a single circuit. After three years of shows outside, I've yet to flip the breaker.

6 - T39 3012LF
4 - OT12 2512
1 - T24
1 - SLA Pro
2 - XF210


"A system with a few knobs set up by someone who knows what they are doing is always better than one with a lot of knobs set up by someone who doesn't."

User avatar
Tom Smit
Posts: 7457
Joined: Sat Jan 05, 2008 1:24 pm
Location: Sarnia, Ont. Canada

Re: 8 x DR250 build

#138 Post by Tom Smit »

CoronaOperator wrote:should be fixed now
:clap:
TomS

Post Reply