It is currently Mon Nov 20, 2017 4:23 am

All times are UTC-05:00




Post new topic  Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Thu May 11, 2017 11:13 pm 
Offline

Joined: Tue Jun 07, 2016 2:41 pm
Posts: 12
Location: montgomery, tx
In the plans Bill mentions that it is easier to mount drivers when you make two access holes, one on each side. My question is why is the first access hole cut near the beginning of assembly and the other cut toward the end? Is there a reason both could not be cut at the same time?


Top
   
PostPosted: Fri May 12, 2017 12:32 am 
Offline
User avatar

Joined: Sat Jan 05, 2008 1:24 pm
Posts: 6340
Location: Sarnia, Ont. Canada
If you built it perfectly, then it would make sense. However, some "drift" seems to accompany the build and therefore it would be best to mark out the second access when all the panels are installed to accommodate that "drift".

_________________
TomS


Top
   
PostPosted: Fri May 12, 2017 6:51 am 
Offline

Joined: Fri Nov 27, 2009 11:37 am
Posts: 6092
Location: New Braunfels, TX
Tom Smit wrote:
If you built it perfectly, then it would make sense. However, some "drift" seems to accompany the build and therefore it would be best to mark out the second access when all the panels are installed to accommodate that "drift".


+1

No matter how meticulous you are in aligning panels, the expanding PL glue will push some panels out a little.

_________________

6 - T39 4-25" 2-22" 3012LF
4 - OT12 2512 Melded/NSD2005
1 - T24
2 - XF210


"A system with a few knobs set up by someone who knows what they are doing is always better than one with a lot of knobs set up by someone who doesn't."


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 3 posts ] 

All times are UTC-05:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
banner
Powered by phpBB® Forum Software © phpBB Limited